KH1 Power Switch Guard Color:Red This is a printed stand

This is a printed stand for the AX1 antenna

Wire is Polystealth 26awg for ultimate portability

Wire length if included in selection is cut to length and terminated with banana connectors at the transformer and loops at the opposite ends

overheating

These boards are 3D printed in PLA+ for a higher temperature allowance and to better handle the outdoor elements

KH1 Power Switch Guard Color:Red This is a printed standHelp prevent your KH1 from turning on in the case! Don't pull out the KH1 to find its dead! Printed in UV resistant, high temp ASA Filament. Hardware included. Insert square nut into slot and screw in from inside back radio cover as seen in photo. Radio Not Included!